System procedures

CAD/CAM/CAE systems must be controlled, supported, and maintained by well-conceived procedures if they are to perform effectively. The procedures will be specific to the system and, for the most part, their use should be restricted to the system support team. The following are usually required.
Naming convention procedure
Back-up procedure
Archive procedure
Vendor interface procedure
Enhancements procedure
CAD/CAM/CAE output procedure
Security procedure
Disaster procedure

Home | Top of page | Front of MANAGING CAD/CAM/CAE section

Page last modified on February 11, 2000
Copyright 1999, 2000 by John Stark